Advantage of bmw e39 angel eyes upgrade is with canbus , no flashing , no error message , no warning alarm, no radio interference. as light source for angel eyes ring .Directly place on vehicle front left and right.
Date of bmw e39 angel eyes upgrade
Watt: E39 5W
Led quantity: 1 LED Bridgelux
Lumen: 380-420 LM
Color : 6500K White ( customized color is available )
Life time :50000-100000 Hours
Material :Plastic and aluminum
Weight:176g /set (with box )
Gift box /set
Carton Measure ：29*52*27CM
Warranty ：1 Year
bmw e39 angel eyes upgrade fit to below models :
04-07 1series E87 pre-lci (5door)
01-03 5series E39 face-lifted (525i, 530i, 540i)
00-03 5-series E39 M5
04-07 5-series E60 （525i,525xi, 530i, 530xi, 545i, 550i)
06-07 5-series E60 M5
06-07 5-series E61 Touring (530xi)
04-07 6-series E63 / E64 (645ci, 650i)
06-08 6-seies E63/ E64 M6
02-08 7-seies E65/ E66 (745i, 745Li, 750i,750Li,760i, 760Li, B7 alpina)
06-07 E83 x3
00-06 E53 x5
07-09 E60 520D
The problem you may meet when install bmw e39 angel eyes upgrade .
Many BMW owners have wiring issues when install the bmw e39 angel eyes upgrade, or some owners are confused with the lighting disasters. Most people figure out the problem and do not know how to fix it .
In such cases, customers complain about the fixture failure in lighting the outer ring and think it as a fault with lighting fixture. It is actually a flaw in installation process that leads to this problem ,not the fault of lighting fixture , if you installed properly the angel eyes in car , then the outer ring will be as brighter as the inner ring and illuminate properly.
If you view closely the headlight installed in BMW series , such as E92 3 series , you may clearly observe and see that two different optical fiber cable from the headlight panel . There two cable are actually responsible for traveling the light from the headlight to the outer rings. Therefore , this is the most important step , which is usually overlooked by most of people during the installation of angel eyes .
When you install led marker angel eyes into your vehicle , you must be very cautious , a slight change may effect the lighting variations at the last stage after the completion of installation process. You need to be sure that two light emitters of the led marker are placed directly to face the opening of the angel eyes tubes , this will ensure that the optical fiber cable travel sufficient amount of light to the angel eyes outer ring with adequate illumination performance.
There is no other choice for that mentioned problem. You need to ensure that the light emitters of BMW led marker are placed in the right location to provide sufficient amount of light so that it would not light up only slightly . If you do not end up committing this mistake , do worry you can still pulling out the led marker light from the assembly and turning it 120 degrees around. And insert again into the assembly , by doing that , you can ensure the led emitters are placed in correct direction to the hole and supply sufficient amount of light for the outer ring for your BMW angel eyes, like following picture , the outer ring is full bright.